Substantiation of Parameters of Working Body of the Combined Unit for Repeated Crops

  • Nasritdinov Akhmadzhon Abdukhamidovich Namangan Engineering Technological Institute
  • Djurayev Ismoilxuja Kadir ugli Namangan Engineering Technological Institute
  • Haydaraliyev Otabek Habibulloevich Namangan Engineering Technological Institute
  • Toshboyeva Maftuna Qurvonali Qizi Namangan Engineering Technological Institute
DOI: https://doi.org/10.31149/ijot.v3i5.1780
Keywords: a disk, the plough case, a corner of a point of a disk, diam

Abstract

In article the substantiation technological and design data depth of immersing, a corner of a point of a disk, diameter of a disk of the adaptation to a general purpose plough is considered.

References

1. Klyonin N.I., Sakun V.A. Agricultural and melioration machines. – M .: Kolos, 1980. ¬ – 672 p.
2. Sergienko V. A., Baimetov R. I., Mansurov K. M. Basic tillage of the Karshi steppe zone.- Tashkent. Fan, 1982. -64 p
3. Sineokov G. N., Panov I. M. Theory and calculation of tillage machines. - M.: Mashinostroenie. – 1977. -326 p
Published
2021-05-10
How to Cite
Abdukhamidovich, N. A., ugli, D. I. K., Habibulloevich, H. O., & Qizi, T. M. Q. (2021). Substantiation of Parameters of Working Body of the Combined Unit for Repeated Crops. International Journal on Orange Technologies, 3(5), 13-17. https://doi.org/10.31149/ijot.v3i5.1780
Issue
Vol. 3 No. 5 (2021): IJOT
Section
Articles

Copyright (c) 2021 International Journal on Orange Technologies

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.