Optimization and control in the chemical processes
Abstract
Control is a good alternative solution to obtain the desired product yield and still maintain the safety conditions, without changing the system’s configuration or replacing the existent components with new ones. A mathematical model of a thermal cracking coil was developed, based on free radical mechanism and some basic assumptions. In order to predict the coil’s behavior (temperature, product yields and pressure), a simulator for the dynamic process was used. This paper represents a preliminary dynamic behavior study for implementing advanced process control and optimization.
References
Ахмадова Х.Х. СТАНОВЛЕНИЕ И РАЗВИТИЕ ОТЕЧЕСТВЕННЫХ СИСТЕМ ТЕРМИЧЕСКОГО КРЕКИНГА - Диссертация на соискание ученой степени доктора технических наук. Уфа-2013 г. 457 с.
A. Niaei, J. Towfighi, et al., 2004, “The combined simulation of heat transfer and pyrolysis reactions in industrial cracking furnace” Applied Thermal Engineering 24 (2004) pp. 2251–2265.
K. M. Van Geem, R. Zajdlik, et al., 2007, “Dimensional analysis for scaling up and down steam cracking coils” Chemical Engineering Journal 134 (2007) pp. 3–10.
Program: MATLAB R 2008A, © 1984-2008 The Math Works, Inc. Simulink. Subsystem. Delete Contents, Simulink. Block Diagram. Copy contents to Subsystem, Simulink. Subsystem. Convert to model Reference.
Програмы: КОМПАС-3D V13, Часть 5. Общие сведения.
B.G. Houk, et al., 1995, “Model predictive control of a delayed coking unit [DMC]: Development Issues”, Chem. Technol. Eur., vol.2, pp. 20-24.
Application of matlab system for performance of laboratory works on the subject of the theory of automatic control. Pulotova Mohira Rahmatilloyevna, Namozov Shohrukh Ilyos o`g`li, Muinov Ulugbek Bahtiyerovich. Вестник науки и образования журнал. 10-2 (64), 2019.
3.png)
